--- In GrizHFMinimill@yahoogroups.com, Brian Pitt <bfp@...> wrote:
>
> On Wednesday 14 September 2011 17:45:09 olduhfguy wrote:
> > One of the things I would like to do with my new HF mill is to use it to notch tubing and angle stock to accept round tubing for mig welding. I remove the pilot from my hole saw, and use the mill to make the cut. Unfortunately my 'good' holesaw mandrel has a hex shank, which of course I can chuck up in the 1/2 chuck, but this creates a very long tool with potential for wobble and other problems. If I could find an R8 hex collet, life would be good. I have seen 5C hex collets but no R8. I'm thinking maybe I should find an R8 blank and cut a thread that the holesaws would thread on to, but there must be a better way, right ?
>
> Hardinge has 7/16 and 5/8 hex and a couple square sizes
> (you may want to be sitting down when you click on the link ;)
> http://www.shophardinge.com:80/product.aspx?partNo=17570029004375
>
> Brian
> --
> Nemo Me Impune Lacessit
>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/GrizHFMinimill/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/GrizHFMinimill/join
(Yahoo! ID required)
<*> To change settings via email:
GrizHFMinimill-digest@yahoogroups.com
GrizHFMinimill-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
GrizHFMinimill-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/