In hoping to speed tool changes in my mini mill, I have purchased a collet chuck set MT#3 ER-32.
I hate to ask but my question is this: How do you properly load a collet as well as your cutting bit into the chuck? Is it simply held in place by the nut? (I understand that the spanner tightens the nut) If so how do you remove the collet after removing the nut?
I know it is a basic question but how is this done the right way?
Once again thank you all for you advice and support.
-Lee
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/GrizHFMinimill/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/GrizHFMinimill/join
(Yahoo! ID required)
<*> To change settings via email:
GrizHFMinimill-digest@yahoogroups.com
GrizHFMinimill-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
GrizHFMinimill-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/