On Sat, 01 Oct 2011 16:41:13 -0000, "amriensr" <
amriensr@yahoo.com>
had a flock of green cheek conures squawk out:
>Hi folks. I picked up one of the KB boards used in this message.
>
http://szabaga.com/x2/power/>I was wondering how many of you folks are using this specific board on your mini mill, and if you wired it exactly as shown. I'm mainly concerned about the motor hookup. I seem to recall reading a post some time ago where someone had to connect their motor wires to points different than is shown in order for it to work properly.
>Thanks
He has the motor wired to the motor field coil connections. The only
other motor connections are the A- & A+, usually A is for armature.
--
Stephen
(On September 17, 1994, Alabama's Heather Whitestone was selected as Miss America 1995.)
Question: If you could live forever, would you and why?
Answer: "I would not live forever, because we should not live forever, because if we were supposed to live forever, then we would live forever, but we cannot live forever, which is why I would not live forever,"
--Miss Alabama in the 1994 Miss USA contest.
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/GrizHFMinimill/<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/GrizHFMinimill/join (Yahoo! ID required)
<*> To change settings via email:
GrizHFMinimill-digest@yahoogroups.com GrizHFMinimill-fullfeatured@yahoogroups.com<*> To unsubscribe from this group, send an email to:
GrizHFMinimill-unsubscribe@yahoogroups.com<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/