[GrizHFMinimill] Treadmill motor with stock controller?

For those out there that have used a treadmill motor on their mini mill, did you try it with the stock mill board? I tried mine and it would turn on for a few seconds and then shut down. I don't know a whole lot about electronics on these boards and was looking for ideas. I haven't tried playing with the speed pots at all, don't know if it will matter. My motor is a 2.25 treadmill duty 4 wire (2 blue) and works fine with the M60 controller. I don't like how the M60 speeds up and slow down so slow though. Any one have any experience?

------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/GrizHFMinimill/

<*> Your email settings:
Individual Email | Traditional

<*> To change settings online go to:
http://groups.yahoo.com/group/GrizHFMinimill/join
(Yahoo! ID required)

<*> To change settings via email:
GrizHFMinimill-digest@yahoogroups.com
GrizHFMinimill-fullfeatured@yahoogroups.com

<*> To unsubscribe from this group, send an email to:
GrizHFMinimill-unsubscribe@yahoogroups.com

<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/