>
>>
> I'm sure some will say the clutch handle blocks off the end of the t-bolt slot and eventually I'd like to figure out a different way to engage the clutch but the clearances under the bed are pretty restrictive when the carriage runs to the full right position. I'm open to suggestions....
>
>
Put a couple of Tee nuts into the slot from the other end and leave them there.
Nice job, best regards,
David Clark in Southern Maryland, USA
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/GrizHFMinimill/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/GrizHFMinimill/join
(Yahoo! ID required)
<*> To change settings via email:
GrizHFMinimill-digest@yahoogroups.com
GrizHFMinimill-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
GrizHFMinimill-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/