[GrizHFMinimill] Re: Y Axis Thrust Washers and Locknut

I know this is an old thread, but I just got a pair of the thrust washers from David Clarke. I'm trying to install them in a cold garage. I can't seem to get the bearing housing off the Y axis lead screw. It should just pull off, right? The hand wheel came off o.k., and I will replace the two lock nits with a nylock nut as advised in David's instructions.

Chuck in E. TN

------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/GrizHFMinimill/

<*> Your email settings:
Individual Email | Traditional

<*> To change settings online go to:
http://groups.yahoo.com/group/GrizHFMinimill/join
(Yahoo! ID required)

<*> To change settings via email:
GrizHFMinimill-digest@yahoogroups.com
GrizHFMinimill-fullfeatured@yahoogroups.com

<*> To unsubscribe from this group, send an email to:
GrizHFMinimill-unsubscribe@yahoogroups.com

<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/