Any suggestions of how best to add a spindle lock to my Micro-Mark R8 mill? Today I made a new cutter from a piece of drill bit and then used the Z axis to make my first internal keyway. (I was replacing a broken handle on my lathe.). I was quite pleased with how the keyway turned out, but I had to jury-rig a means to lock the spindle. I'd like to add a lock that would let me fine tune the direction the cutter is pointing, if that makes any sense.
Thanks,
Karl
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/GrizHFMinimill/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/GrizHFMinimill/join
(Yahoo! ID required)
<*> To change settings via email:
GrizHFMinimill-digest@yahoogroups.com
GrizHFMinimill-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
GrizHFMinimill-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/