Responding to Bill in Boulder. I fitted a longish turnbuckle on the
rear of my mill (X2) column as for some reason it tended to lean forward
out of tram.
Quick fiddle on the turn buckle brings it back into line. I do have
smaller turnbuckles I intended to set either side for lateral tramming
but yet to do as so far I manage to adjust easily enough.
Oh. I did also bung a chunk of 12mm (1/2") plate stiffener and
ditched the Belvue washer. That helped a lot but flexing still happens
when I get too enthusiastic on the cut and feed. Patience, John Patience.
--
Regards, John B
------------------------------------
Posted by: John Bernoth <jbernoth1@bigpond.com>
------------------------------------
------------------------------------
Yahoo Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/GrizHFMinimill/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/GrizHFMinimill/join
(Yahoo! ID required)
<*> To change settings via email:
GrizHFMinimill-digest@yahoogroups.com
GrizHFMinimill-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
GrizHFMinimill-unsubscribe@yahoogroups.com
<*> Your use of Yahoo Groups is subject to:
https://info.yahoo.com/legal/us/yahoo/utos/terms/