On Mon, 15 Feb 2016 09:35:12 -0500, you wrote:
Check your posting status. If you are moderated, then your posts are
in limbo waiting to be approved before posting. This can take a
little bit of time since the moderators check the notifications from
Yahoo periodically, but not as frequently as you may think.
It will take a little for your post to show up, sometimes several
hours depending on what the moderators are doing.
Harvey
(moderator)
>Don't know the answer, but your post is up (all three times).
>
>Warren L
>
>On 2/15/2016 9:03 AM, Flatfoot Mowers ffmowers@cox.net [GrizHFMinimill]
>wrote:
>>
>> I'm trying this again; I posted a while ago and it never showed up.
>>
>> I have the Grizzly mini mill with the belt drive upgrade. As part of
>> that, I removed the intermediate shaft and gears as they were no
>> longer needed. Got rid of the speed lever while I was at it also.
>>
>> I bought the mill knowing the spindle bearings needed to be replaced
>> and am doing that now. The question is;
>>
>> Is there any reason I need to re-install the spindle gear and spacers?
>> They aren't used for anything I can think of and I could just install
>> the spindle without them; Lower Bearing and Upper Bearing only with
>> the spindle and spindle nut of course, as well as the bearing covers.
>>
>> Not installing the gears would simplify things for sure.
>>
>> Any thoughts?
>>
>>
>>
>> ------------------------------------------------------------------------
>> Avast logo <https://www.avast.com/antivirus>
>>
>> This email has been checked for viruses by Avast antivirus software.
>> www.avast.com <https://www.avast.com/antivirus>
>>
>>
>>
------------------------------------
Posted by: Harvey White <madyn@dragonworks.info>
------------------------------------
------------------------------------
Yahoo Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/GrizHFMinimill/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/GrizHFMinimill/join
(Yahoo! ID required)
<*> To change settings via email:
GrizHFMinimill-digest@yahoogroups.com
GrizHFMinimill-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
GrizHFMinimill-unsubscribe@yahoogroups.com
<*> Your use of Yahoo Groups is subject to:
https://info.yahoo.com/legal/us/yahoo/utos/terms/