Re: [GrizHFMinimill] Wiring a KBWS-25D to mini mill



I've just wired them as the board is marked. Fuse 120 vac in arm+ and arm - out and fuse again.
If you contact KB they will help you out, regardless of where, or when you bought the board.


On Monday, June 3, 2019, 11:09:19 AM EDT, gorf242003@yahoo.com [GrizHFMinimill] <GrizHFMinimill@yahoogroups.com> wrote:




I have a KBWS-25D motor controller I am replacing a blown mini mill controller..


Want to see if anyone Knows hot to connect wires 6 and 7 to the kb they look like there going to the on off switch and when on create contact between 6 and 7 but, I can't see where 6 an7 go from the old controller in the diagram it shows a trace from the switch to 6 and 7 on the board but no traces showing where they go once screwed to the board.....


Want to make sure its right don't want to blow up the new board..


Thanks gary






__._,_.___
Posted by: amriensr@yahoo.com



__,_._,___