Graciously,
Jim E.
Lakewood, Calif.
All Hail Rube Goldberg!
David wrote:
> I'm not endorsing anything. I had the rather unpleasant mishap when I went to drill a hole in the bottom of the original controller box and when the 1/2 inch bit I was using broke through the plastic as it will it grabbed and I pulled, anyway I ran the drill bit across the full width of the board, now let me tell you this is a sinking feeling like someone just jerked the boat out from under you...
>
> Well after looking at the board, and a little research I found KB Electronic which made the board I trashed, and probably makes the board in the mill that you have.
>
> I found and purchased mine for what it was going to cost to get one from somewhere else for the same money and I got it local. The only thing I had to do was to install the resistor and there was something else but there was one on the board that I trashed (by the way is someone wants I can let them have it for a very good price) I did not get the FWD/REV Brake switch setup, I installed a DPDT toggle adn it has been fine since. I was also able to move the box from the side of the mill head to the back of the column which is a more sensible place for it as it clears up the side of the head on the left.
>
> Anyway heres the reason for this long post, http://www.kbelectronics.com/
>
> anyone got controller problems and need a new one go direct to the source, you can also at times find the same or similar controllers on the Evil B#$%y for like 20 bucks, I have one from Minarac I gave 20 and shipping for 90 volt controller will handle up to a 1 hp motor. gonna stick it on my column drive for my ZX45 mill.
>
> --- In GrizHFMinimill@yahoogroups.com, J RUDD <john.rudd@...> wrote:
>
>>Yes,
>>
>>Another endorsement for KBC.
>>
>>My mill has the KBL240 with no issues so far.
>>
>>regards
>>J
>>
>
>
>
>
>
> ------------------------------------
>
> Yahoo! Groups Links
>
>
>
>
>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/GrizHFMinimill/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/GrizHFMinimill/join
(Yahoo! ID required)
<*> To change settings via email:
GrizHFMinimill-digest@yahoogroups.com
GrizHFMinimill-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
GrizHFMinimill-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/