Manual for the KBLC DC motor speed control from KB:
www.kbelectronics.com/manuals/kblc.pdf
F (field) is only used for shunt wound motors. If yours has magnets,
then you don't use this one.
For most treadmill motors and the original X2 motor, use the A
(armature) connections.
On Sat, 1 Oct 2011 16:17:52 -0700 (PDT), a rien <
amriensr@yahoo.com>
had a flock of green cheek conures squawk out:
>Thanks..But how do you figure out which of the two choices is the correct one??
>
>--- On Sat, 10/1/11, Stephen Castello <
zootzoot@stephenrc.com> wrote:
>
>From: Stephen Castello <
zootzoot@stephenrc.com>
>Subject: Re: [GrizHFMinimill] KB power supply/speed control
>To:
GrizHFMinimill@yahoogroups.com>Date: Saturday, October 1, 2011, 1:10 PM
>
>On Sat, 01 Oct 2011 16:41:13 -0000, "amriensr" <
amriensr@yahoo.com>
>had a flock of green cheek conures squawk out:
>
>>Hi folks. I picked up one of the KB boards used in this message.
>>
http://szabaga.com/x2/power/>>I was wondering how many of you folks are using this specific board on your mini mill, and if you wired it exactly as shown. I'm mainly concerned about the motor hookup. I seem to recall reading a post some time ago where someone had to connect their motor wires to points different than is shown in order for it to work properly.
>>Thanks
>
>He has the motor wired to the motor field coil connections. The only
>other motor connections are the A- & A+, usually A is for armature.
--
Stephen
Movie fact:
If you decide to start dancing in the street, everyone you bump into will know all the steps.
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/GrizHFMinimill/<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/GrizHFMinimill/join (Yahoo! ID required)
<*> To change settings via email:
GrizHFMinimill-digest@yahoogroups.com GrizHFMinimill-fullfeatured@yahoogroups.com<*> To unsubscribe from this group, send an email to:
GrizHFMinimill-unsubscribe@yahoogroups.com<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/