[GrizHFMinimill] Back to Rick's power feed clutch actuator

I probably need to look again, but after checking late last night, there doesn't seem to be any easy way to get a rod actuator in to where the clutch is from the motor side of the mounting plate.

So, back to Rick's idea with the levered screw.

Rick,
I was going to ask for measurements of pretty much everything but then thought about it. Did you cut both sides of the clutch and the cam-pin screw and then just figure out where to drill the table top by playing with the clutch from the bottom?

Also, in another message, you mentioned the pin (or the little lever) moves from the 10 o' clock position to 2 o' clock. It looked like it just moved 180 degrees when you moved it. Does it rotate more or am I missing something else?

------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/GrizHFMinimill/

<*> Your email settings:
Individual Email | Traditional

<*> To change settings online go to:
http://groups.yahoo.com/group/GrizHFMinimill/join
(Yahoo! ID required)

<*> To change settings via email:
GrizHFMinimill-digest@yahoogroups.com
GrizHFMinimill-fullfeatured@yahoogroups.com

<*> To unsubscribe from this group, send an email to:
GrizHFMinimill-unsubscribe@yahoogroups.com

<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/